GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
7-120 Section 7-6 - Performing Back End Diagnostics on the System
PRELIMINARY
7-6-1 Accessing the Back End Diagnostic Test Options (cont’d)
6.) To resume testing (from the point where you paused), trackball to the Start button and press Set.
When the CPU Full Test sequence is complete:
- the Diagnostic Test window displays the Finished message
- the View Test Log window opens automatically, listing all tests performed and showing details
of which tests and sub-tests passed or failed, as shown in the example in Figure 7-78 "View
Test Log - Full Back End Test w/o Hard Disk Scan" on page 7-116.
NOTE: For the CPU Full Test, many tests are performed in the test sequence; these are listed in the
Tests window as shown in Figure 7-80. For each currently-selected test (for example,
Registers) the corresponding report is listed in Reports on the right.
7.) Use the scroll bars and/or arrows to scroll through the list of Test results and review the reports, as
required:
-CPU Registers
- CPU Arithmetics
- CPU String Operations
- CPU Logical Operations
- CPU Math Registers
- CPU Math Commands
- CPU Transcendental
- CPU MMX Arithmetic
- CPU MMX Logical
- CPU MMX Shift
- CPU MMX Data Transfer
- CPU MMX Misc.
8) When done, trackball to the Exit button and press Set to close the View Report window.
9) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If no problems were identified but the problem persists, contact your local GE HEALTHCARE
field engineer for assistance.
• If errors were identified and the results were not marginal, verify that all system cables and
boards are connected (not misplaced) and functioning properly, as described in Chapter 5 -
Components and Function (Theory).
Figure 7-82 View Test Log - CPU Full Test
To Next Page
Loading...
