GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-54 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
4.) Remove the spring clips securing the particular handle to be removed - Figure 8-67.
5.) Release the small spring that presses on the handle to be replaced - Figure 8-68.
6.) Release the tension in the up-down/swivel cables by pressing the cable tension levers inwards.
Figure 8-67 Removing Spring Clip that Secures the Swivel Handle
Figure 8-68 Releasing Spring that Presses on the Handle
Spring Clip
Swivel Handle
Up-down Handle
To Next Page
Loading...
