GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-217
PRELIMINARY
12. IMPORTANT.
Perform these steps before proceeding!
a.)Remove the USB Flash Drive from the USB port on
the Front of the Operator Panel.
b.)Check that no other media is connected to the system
(e.g. DVD drive).
c.)Press [OK] to continue.
The system reboots and then begins the software installation process.
This stage of the process takes approximately 20 minutes, during which time a
progress indicator is displayed, as shown in the example below:
A series of progress bars, blank and additional screens are displayed, shown
in these examples:
Table 8-2 Step-by-Step Software Upgrade/Installation/Reinstallation Procedure (cont’d) 5 of 9
Step Instruction Expected Result
To Next Page
Loading...
