GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-220 Section 8-8 - Software Loading
PRELIMINARY
At the end of the software installation, the Software License dialog box appears.
14. Type in the option key that you received from the OTR
and click OK.
Note: Do not use option keys from the previous
BT version.
The system will boot-up into Normal scanning mode.
15. Press Config. The Operator Logon screen opens.
16. Type the following to log into the system:
Operator: ADM
Password: ulsadm
Click Logon.
The normal scanning screen is displayed.
17. To verify the software version, press Config, then click
About at the bottom of the screen. Select the System
Version tab.
The About Screen opens, and from the System Version tab, the installed
software version details are displayed.
Table 8-2 Step-by-Step Software Upgrade/Installation/Reinstallation Procedure (cont’d) 8 of 9
Step Instruction Expected Result
To Next Page
Loading...
