GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-239
PRELIMINARY
d.) Plug the USB connector into the previously-vacated USB port on the Vivid S5/S6 chassis as
shown in Figure 8-273.
4.) Plug the mini USB connector into the DVD/CD port located at the rear of the DVD/CD drive as
shown in Figure 8-274.
5.) Re-fit the DVD cover making sure it is seated correctly - then secure the DVD cover in position and
tighten the two Phillips screws ((refer to Figure 8-25 on page 8-24)).
6.) Return and fasten the two Phillips screws previously removed from either side of the securing panel
(refer to Figure 8-269 on page 8-236). Make sure the DVD /CD-RW Drive is firmly secured in
position.
7.) Return the bottom rear cover, as described in the “Bottom Rear Cover Installation Procedure” on
page 8-23.
8.) Return the Vivid S5 N or Vivid S6 N front cover, as described in the “Front Cover Installation
Procedure” on page 8-19.
9.) Return the Vivid S5 N or Vivid S6 N left and right side covers, as described in the “Left Side Cover
Installation Procedure” on page 8-7 and “Right Side Cover Installation Procedure” on page 8-5.
10.)Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
11.)Insert a CD-R disk in the DVD /CD-RW Drive. Then eject and remove the CD-R disk to check the
eject mechanism functions properly.
Figure 8-273 USB Connector Plugged into the USB Port
Figure 8-274 Mini USB Connector Plugged into DVD/CD
The second USB port on the left.
Plug the USB connector into the
J14B port
To Next Page
Loading...
