GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-21
PRELIMINARY
8 Control Panel up/down release handle:
Enables locking of the control panel in position, or changing the
location of the arm by moving it upwards and away from the user,
or downwards and away from the system. This provides leg room
for the user who may then be seated beside the system.
9 Rear Caster: Enables free rolling and swiveling. On Vivid S6 N systems, also
enables full-locking of swivel motion.
10 Front Caster: Enables full-locking of swivel motion, or free rolling and swiveling.
NOTE: Each Front and Rear Caster wheel is covered with an adhesive pad to provide protection and eliminate
the risk of possible damage during shipping. After installation, carefully remove the protective pads from
all casters, as illustrated Figure 3-16, below.
11 ECG Connector: Provides External ECG input connection to an ECG monitor device
outlet, or direct patient three-contact ECG lead connection.
Important: Do not use the Vivid 7 ECG cable with the
Vivid S5 N or Vivid S6 N system.
12 Speakers: Two loudspeakers provided for Doppler sound.
13 Air inlet and Sub woofer: Air flow is via a built-in filter on the side cover, for system air
cooling. A sub-woofer speaker provides superb sound.
14 ON/OFF: Power ON/OFF knob enables the user turn ON the system (when
power is connected and the system is either in Shutdown or
Standby mode).
15 Probe Connectors: Vivid S6 N system
5 active probe connectors
(3 RS probe connectors, one connector for a pencil probe, and one
LOGIQ-type connector for TEE probes).
Vivid S5 N system
4 active probe connectors
(3 RS probe connectors, and one connector for a pencil probe
Figure 3-16 Removing Protective Pad from Caster Wheels
To Next Page
Loading...
