HEIDENHAIN TNC 620 Programming Station

Contents
4 Tools.........................................................................................................................................121
4.1 Entering tool-related data...............................................................................................................122
Feed rate F...................................................................................................................................................................122
Spindle speed S.......................................................................................................................................................... 123
4.2 Tool data........................................................................................................................................124
Requirements for tool compensation.................................................................................................................... 124
Tool number, tool name........................................................................................................................................... 124
Tool length L................................................................................................................................................................124
Tool radius R............................................................................................................................................................... 126
Delta values for lengths and radii...........................................................................................................................126
Entering tool data into the NC program................................................................................................................127
Calling the tool data...................................................................................................................................................128
Tool change................................................................................................................................................................. 130
4.3 Tool compensation.........................................................................................................................133
Introduction..................................................................................................................................................................133
Tool length compensation........................................................................................................................................133
Tool radius compensation........................................................................................................................................134
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
11