HEIDENHAIN TNC 620 Programming Station

Special functions | NC functions for coordinate transformations
10
Notes
This function can only be used in the FUNCTION MODE MILL
machining mode.
Further information: User's Manual for Setup, Testing and
Running NC Programs
If you want to reduce the size of a contour with inside radii, make
sure to select an appropriate tool. Otherwise, residual material
might remain.
Selecting a TRANS function
To select a TRANS function:
Show the soft-key row with special functions
Press the PROGRAM FUNCTIONS soft key
Press the TRANSFORM / CORRDATA soft key
Press the TRANSFORMATIONS soft key
Press the soft key for the desired TRANS function
390
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022