HEIDENHAIN TNC 620 Programming Station

Programming aids | Adding comments
6
Changing a comment for an NC block
Proceed as follows to change a commented-out NC block to an
active NC block:
Select the comment block you want to change
Press the REMOVE COMMENT soft key
Alternative:
Press the > key on the alphabetic keyboard
The control removes the semicolon ; at the
beginning of the block.
Press the END key
Functions for editing a comment
Soft key Function
Jump to beginning of comment
Jump to end of comment
Jump to the beginning of a word. Use a space to
separate words
Jump to the end of a word. Use a space to
separate words
Switch between insert and overwrite mode
196
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022