HEIDENHAIN TNC 620 Programming Station

First steps | Overview
2
2.1 Overview
This chapter is intended to help you quickly learn to handle the most
important procedures on the control. For more information on the
respective topic, see the section referred to in the text.
The following topics are covered in this chapter:
Switching on the machine
Programming the workpiece
The following topics are covered in the User's Manual for
Setup, Testing and Running NC Programs:
Switching on the machine
Graphically testing the workpiece
Setting up tools
Setting up the workpiece
Machining the workpiece
50
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022