Programming Q Parameters | Additional functions
10
424
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
FN 37: EXPORT
NOTICE
Danger of collision!
Changes to the PLC can result in undesired behavior and
serious errors (e.g., inoperability of the control). For this reason,
access to the PLC is protected by password. The FN function
provides HEIDENHAIN as well as your machine tool builder and
suppliers the ability to communicate with the PLC from an NC
program. It is not recommended that the machine operator or
NC programmer use this. There is risk of collision during the
execution of the function and during the subsequent processing!
Only use the function in consultation with HEIDENHAIN, the
machine tool builder, or the supplier.
Comply with the documentation from HEIDENHAIN, the
machine tool builder, and suppliers.
You need the FN 37: EXPORT function if you want to create your
own cycles and integrate them in the control.
FN 38: SEND – Send information from NC program
The function FN 38: SEND enables you to write texts and Q
parameter values to the log from the NC program and send to a
DNC application.
Data transmission is through a standard TCP/IP computer network.
For more detailed information, consult the Remo Tools
SDK manual.
Example
Document values from Q1 and Q23 in the log.
FN 38: SEND /"Q parameter Q1: %f Q23: %f" / +Q1 / +Q23
To Next Page
Loading...
Need help?
General
