Programming aids | Calculator
6
Calculator function Command (soft key)
Unit of measure MM or INCH
Show angular value in radians (default:
angular value in degrees)
RAD
Select numerical value notation DEC (decimal) or HEX
(hexadecimal)
Transferring the calculated value into the NC program
With the arrow keys, select the word into which the calculated
value is to be transferred
Show the calculator by pressing the CALC key, and perform the
desired calculation
Press the CONFIRM VALUE soft key
The control transfers the value into the active input field and
closes the calculator.
You can also transfer values from an NC program into
the calculator. When you press the GET CURRENT VALUE
soft key or the GOTO key, the control transfers the value
from the active input field to the calculator.
The calculator remains in effect even after a change in
operating modes. Press the END soft key to close the
calculator.
Functions in the pocket calculator
Soft key Function
Transfer the nominal or reference value of the
respective axis position into the calculator
Transfer the numerical value from the active input
field into the calculator
Transfer the numerical value from the calculator
into the active input field
Copy the numerical value from the calculator
Insert the copied numerical value into the calcula-
tor
Open the cutting data calculator
You can also move the calculator with the arrow keys of
your alphabetic keyboard. If you have connected a mouse
you can also position the calculator with this.
202
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
To Next Page
Loading...
