Introduction | Modes of operation
2
92
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Programming
In this mode of operation you create NC programs. The FK free
programming feature, the various cycles and the Q parameter
functions help you with programming and add necessary
information. If desired, you can have the programming graphics
show the programmed paths of traverse.
Soft keys for selecting the screen layout
Soft key Window
Program
Left: program, right: program structure
Left: program blocks, right: programming graph-
ics
Test Run
In the Test Run mode of operation, the control checks NC
programs and program sections for errors, such as geometrical
incompatibilities, missing or incorrect data within the program
or violations of the working space. This simulation is supported
graphically in different display modes. (Option 20)
Soft keys for selecting the screen layout
Soft key Window
Program
Left: program, right: status display
Left: program, right: graphics
(option 20)
Graphic
(Option 20)
To Next Page
Loading...
Need help?
General
