Hioki 3166 - Page 348

APPENDIX 14
────────────────────────────────────────────────────
Appendix 2 List of Commands
────────────────────────────────────────────────────
Appendix 2.3 Valid Commands for Each Status
Valid Commands for Each
Initial screen
Menu screen when the power is turned on.
Setting mode
Setting mode screen.
FD mode
Floppy Disk mode screen.
Normal Measurement mode
Continue
Measurement mode status in Normal Measurement
mode.
HOLD
Hold function in use (H mark is displayed).
Wiring check
Incorrect wiring check screen.
Setting
Setting screen for Normal Measurement mode.
Integrated measurement mode
Continue,while integrated
measurement is in progress
Either waiting for the integrated measurement start ke
y
to be pressed, or integrated measurement is in
progress.
Hold, while integrated
measurement is in progress
Hold function is being used in the above state (H mark
is displayed).
Continue, while integrated
measurement is stopped
Either integrated measurement has been stopped or
has ended.
Hold, while integrated
measurement is stopped
Hold function is being used in the above state (H mark
is displayed).
Wiring check
Incorrect wiring check screen.
Setting
Setting screen for Integrated Measurement mode.
Demand measurement mode
Continue, while demand
measurement is in progress
Either waiting for the demand measurement start key
to be pressed, or demand measurement is in
progress.
Hold, while demand measuremen
t
is in progress
Hold function is being used in the above state (H mark
is displayed).
Continue, while demand
measurement is stopped
Demand measurement has ended.
Hold, while demand measuremen
t
is stopped
Hold function is being used in the above state (H mark
is displayed).
Wiring check
Incorrect wiring check screen.
Setting
Setting.
●
Can be executed.
−
Cannot be executed.
Partly
A device-dependent error results while integrated
measurement or demand measurement is in progress
.