Hioki 3166 - Print;Save Items

115
────────────────────────────────────────────────────
7.5 Changing Settings
────────────────────────────────────────────────────
7
.5.5 Print/Save Items
Instantaneous
values
Voltage（U1, U2, U3, Uave
）
Current（I1, I2, I3, Iave）
Power（P, Q, S, λ, ｆ）
Maximum
values
Voltage（U1, U2, U3）
Current（I1, I2, I3）
Power（P, Q, S, λ, ｆ）
Minimum
values
Voltage（U1, U2, U3）
Current（I1, I2, I3）
Power（P, Q, S, λ, ｆ）
Power integration
Active power
(＋WP, −WP, ΣWP)
Reactive power
(＋WQ, −WQ, ΣWQ)
Apparent power
(＋WS, −WS, ΣWS)
Average value within
a time period
Integrated average
values within a time
period, based on the
power integration
Power（P, Q, S, λ）
Load factor（LF）
Usage factor（TLF）
Daily reports
Power integration,
Average value within a time period
,
Maximum demand values
Weekly reports
Power integration,
Average value within a time period
,
Maximum demand values
Monthly reports
Power integration,
Average value within a time period
,
Maximum demand values
These are used to set the items that are to be printed on the printer or saved
on floppy disk. The settings are shared for both devices; it is not possible to
set items so that they are printed on the printer but not saved on floppy disk.
Setting range: Set for 16 blocks
* Items other than power integration, average value within a
time period, and demand are "OFF" (not selected).
* Minimum/maximum value data includes the time at which the
minimum/maximum was generated.
*Not included the load factor and usage factor in demand data, however.