Hioki 3166 - Setting the Time

134
────────────────────────────────────────────────────
8.2 Settings for Each Item
────────────────────────────────────────────────────
8
.2.12 Setting the Time
NOTE
Example Setting the modem initialization command
"ATTE04&C1&D2" is set as the initial value.
Position the cursor at "Modem initialization command (MOD COMMAND)."
Press the CHANGE function key.
The "Command Input" window is displayed.
Up to 50 characters can be input.
Operation is the same as for file name input.
After all changes are complete, press the ENTER function key.
The "Command Input" window closes, and the modem initialization command
in the "Function Setting" window is changed and registered.
This setting is done on the "Function Settings" screen (page 2/2).
Refer to section 8.2, "Settings for Each Item."
Set the correct time whenever necessary.
When the power meter is shipped from the factory, it is set to the current time
in Japan.
The date and time are automatically updated by the auto calendar function.
The auto calendar function can keep track of dates until December 31, 2079.
Setting format: YYYY/MM/DD HH:MM:SS (24-hour time)
For details on setting the time, refer to section 6.5.2, "Start Time."
･ To set the seconds precisely, listen to a reliable time service and press the
SET
key at the "00" seconds mark.
･ The real-time may loss in from 1 to 5 minutes per month. (Within operating
temperature range)