Hioki 3166 - Initial Screen

15
────────────────────────────────────────────────────
2.3 Initial Screen
────────────────────────────────────────────────────
Initial Screen
2
.3 Initial Screen
There are six modes available on the initial screen.
(1) "Normal Measurement" mode
This mode is used to take instantaneous measurements of voltage, current, or
power, and to print out the measured values or save them to floppy disk.
(2) "Integrated Measurement" mode
This mode is used to take integrated power measurements.
(3) "Demand Measurement" mode
This mode is used to continuously take integrated power measurements for
each demand time period (a set time interval).
(4) "Harmonic Measurement" mode (Requires the 9556 HARMONIC ANALYSIS
SOFTWARE, available separately.)
This mode is used to perform harmonic analysis on instantaneous
measurements of voltage, current, or power.
(5) "Setting" mode
This mode is used to set measurement conditions that are common to all of
the measurement modes. Note that these settings can be changed on the
setting screen for all of the measurement modes.