Hioki 3166 - Saving the Settings to Floppy Disk

122
────────────────────────────────────────────────────
7.7 Saving the Settings to Floppy Disk
────────────────────────────────────────────────────
NOTE
7
.7 Saving the Settings to Floppy Disk
Pressing the SAVE key while either page 1 or page 2 of the "Demand
Measurement Settings" screen is displayed causes all of the current power
meter settings to be saved to floppy disk.
In addition to the items that were set in "Demand Measurement" mode, the
special settings that were set for each measurement mode are also saved.
This function can also be executed in the same manner from the setting
screens for each measurement mode.
・For details on saving the settings, refer to section 5.7, "Saving the Settings to
Floppy Disk."
・Note that the saved setting conditions are loaded in "FD" mode. (Refer to
section 14.6.1, "Loading Previously Saved Setting Data.")