Hioki 3166 - Stopping Integrated Measurement

72
────────────────────────────────────────────────────
6.4 Taking Measurements
────────────────────────────────────────────────────
NOTE
6
.4.3 Stopping Integrated Measurement
NOTE
・Once the START/STOP key is pressed, it is no longer possible to change the
measurement range or the contents of the settings, or to reset the data.
To change the settings, it is necessary to first press the START/STOP key again
to stop the integration operation.
・The key lock function can be used when necessary to prevent misoperation. To
activate the key lock condition, press the CHECK key and set "Key Lock" to
ON in the "Check" window. To cancel the key lock condition, press the CHECK
key and set "Key Lock" to OFF.
The end of integration operation for each stop method setting is described
below.
(1) When integration stop is set to "Manual"
The integration operation stops as soon as the START/STOP key is pressed.
(2) When integration stop is set to "Timer"
The integration operation stops automatically after the period of time set as
the integration time.
(3) When integration stop is set to "Time specification"
The integration operation stops automatically at the date and time specified as
the stop time.
(4) When forcibly stopping while in integration standby or while integration is in
progress
The integration operation stops as soon as the START/STOP key is pressed.
The integration operation is forcibly stopped, regardless of whether integration
stop is set to "time specification" or "timer."
・When using the key lock function, cancel the key lock function and then stop
integration either manually or forcibly.
・To display the instantaneous value, maximum/minimum value, or integrated
value measurement data, press the
SCR.KEY function key, and then select the
desired screen from the "Display Selection" window.
・Integration data is retained as long as the DATA RESET key is not pressed.
・Additional integration is possible when "Manual" is set for the integration
start method and "Manual" or "Timer" is set for the integration stop method.
・As long as the integration operation is not stopped, it is not possible to enter
other modes, such as"Normal Measurement or Demand Measurement."