Hioki 3166 - Flow Chart of Basic Operating Procedure

92
────────────────────────────────────────────────────
7.2 Flow Chart of Basic Operating Procedure
────────────────────────────────────────────────────
Select "Demand Measurement" from the initial scree
n
Check for incorrect wiring and confirm that there are n
o
wiring errors
Return to the "Instantaneous Value" scree
n
Check the setting
s
Make special settings needed for integrated measuremen
t,
such as integration start/stop and the integration time
(Refer to section 4.4,
"Wiring Settings and Methods."
)
(Refer to section 4.5,
"Checking for Incorrect Wiring."
)
Wire the power meter to the line being measure
d
Return to the "Instantaneous Value" scree
n
Press the START/STOP key to start integrated
measurement
7
.2 Flow Chart of Basic Operating Procedure
The basic operating methods are the same as for "Integrated Measurement"
mode.