Hioki 3166 - Command Reference; Description of the Command Reference Format

169
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
Synta
x
Indicates the command syntax.
dat
a
Indicates the data format for a command that includes data.
Functio
n
Describes the function of the command.
Not
e
Describes points that require special attention when using the command.
Respons
e
Indicated only for commands for which a response message is returned.
Erro
r
Indicates the what kinds of errors might occur. Note that misspellings are
a type of error that applies to all commands, and are therefore not explicitl
y
mentioned.
Exampl
e
Shows a simple example illustrating the usage of the command. All
transmissions are indicated in "short form."
Transmission: A command that is sent by the controller
Response: Data that is received by the controller
NOTE
1
1.4 Command Reference
1
1.4.1 Description of the Command Reference Format
This section explains each command in detail.
・A "query" is a request to retrieve setting information or measured values. If
an error occurs during a query, no query response message is generated.
・In the case of a system error, the query is not executed and a device-
dependent error results.