Hioki 3166 - Capabilities in Normal Measurement Mode

44
────────────────────────────────────────────────────
5.1 Capabilities in Normal Measurement Mode
────────────────────────────────────────────────────
5
.1 Capabilities in Normal Measurement Mode
The following measurement display functions and data processing functions
can be used in normal measurement mode.
●Display (Refer to section 18.3, "Measurement Items and Calculations"
for details on the items that are displayed.)
(1) Instantaneous value display
(2) Instantaneous value minimum/maximum display (including display of the time
at which the minimum/maximum value was generated)
●Data processing
(1) When a printer is connected: Measured values can be printed manually.
(2) When a FDD unit is connected: Measured values can be saved to floppy disk
manually.
(3) When the D/A output connector is installed: Measured values can be converted
from digital to analog signals and output (for analog recording).
●External control
(1) When a printer is connected: Measured values can be printed under the
control of external control signals.
(2) When a FDD unit is connected: Measured values can be saved to floppy disk
under the control of external control signals.