16
────────────────────────────────────────────────────
2.3 Initial Screen
────────────────────────────────────────────────────
(6) "FD" (Floppy Disk) mode (Requires the 9595 FDD UNIT, available separately.)
This mode is used to load setting conditions and measured values that were
previously saved on floppy disk, to perform file operations, etc.
For details on measurement modes 1 to 4, refer to chapters 5 through 7 and
15, respectively. For details on the "setting" mode, refer to chapter 8. For
details on the "floppy disk" mode, refer to chapter 14.
To Next Page
