HP StorageWorks P9000 - Disk Arrays - Message (part code group 5 nnn); Part code 5105

Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the command device setting is
changed.
LDKC:CU:LDEV
Indicates whether the command device setting is enabled or disabled.
Disable or Enable will appear.
CommandDev
The number of logical volumes where the command device setting is changed.Num. of LDEVs
[PROV] Edit DRU Attribute
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[PROV],Edit DRU Attribute,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,Attribute,RT,Result}
=[{0x00:0x00:0x01,0x80,100,Normal end},
{0x00:0x00:0x02,0x82,Unlimited,Error(9605-8122)},
{0x00:0x00:0x03,0x81,200,Normal end},
{0x00:0x00:0x03,0x81,xxxx,Normal end}],
Num. of LDEVs=XXX
Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the attribute is set.LDKC:CU:LDEV
The set attribute in hexadecimal. Each bit (0–7) of 1 byte corresponds to the setting item. 1 is
assigned to each bit when the setting is enabled and 0 (zero) is assigned to each bit when
the setting is disabled. Each bit represents the following attributes:
• Bit 0: Mounting of LEDV (fixed to 1)
• Bit 1: Setting of S-VOL Disable
• Bit 2: Setting of Zero Read Cap mode
• Bit 3: Setting of Invisible mode
• Bit 4: Setting of reserve
• Bit 5: Fixed to 0 (zero)
*
• Bit 6: Setting of Read Only attribute
*
• Bit 7: Setting of Protect attribute
*
When 0x88 is output to the attribute, for example, Read/Write attribute is set to the logical
volume to show that the reserve setting has been enabled.
A hyphen (-) is output when setting is not changed.
Attribute
The number of days set in Retention Term.
A hyphen (-) is output when setting is not changed.
RT
The result of operation.
Normal end: Normal end, Error (xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of the logical volume(s) where the attribute has been set.Num. of LDEVs
* When bit 5, 6, and 7 are all 0 (zero), Read/Write has been set.
110 Audit log examples