HP StorageWorks P9000 - Disk Arrays - [PROV] Edit Ports(Attr); [PROV] Edit Ports(Security); [PROV] Edit Ports(Speed)

Table 15 Addresses of Fibre Channel Port (continued)
Address
*
ValueAddress
*
ValueAddress
*
ValueAddress
*
Value
01 (125)12645 (93)9475 (61)62B5 (29)30
--43 (94)9574 (62)63B4 (30)31
--3C (95)9673 (63)64B3 (31)32
* Addresses outside parentheses indicate arbitrated-loop physical address (AL-PA). Addresses in parentheses indicate
loop IDs.
[PROV] Edit Ports(Attr)
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Edit Ports(Attr),,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+Attribute=RCU Target
++Port=[1E],Num. of Ports=1
Detailed Information
DescriptionItem
The attribute of the port after change.
Target: Target port, Initiator: Initiator port, RCU Target: RCU Target port, External: External
port
Attribute
The name of the port where the setting is changed.Port
The number of ports where the setting is changed.Num. of Ports
[PROV] Edit Ports(Security)
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Edit Ports(Security),,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,Switch}=[{XX,Disable},{XX,Enable}],Num. of Ports=2
Detailed Information
DescriptionItem
The name of the port where the LUN security setting is changed.Port
Indicates whether the LUN security setting is enabled or disabled.
Disable or Enable is output.
Switch
The number of ports where the LUN security setting is changed.Num. of Ports
[PROV] Edit Ports(Speed)
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Edit Ports(Speed),,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
116 Audit log examples