={((555.666.777.888),(255.255.255.255)),
((9999:AAAA:BBBB:CCCC:DDDD:EEEE:FFFF:0000),(64))}
Basic Information
DescriptionParameter
Change of the IP address for SVPSVP
Change of the IP address for SVP and DKCSVP&DKC
Detailed Information
DescriptionItem
The IP address in SVP.IPAddress
The subnet mask in SVP.Subnet Mask
Indicates whether the Duplex setting in SVP is valid or invalid.
Valid: Valid, Invalid: Invalid
Use Duplex
The kind of duplicated SVP.
Master SVP: Master SVP, Standby SVP: Standby SVP.
SVP Kind
The status of IPv4.
Valid: enabled, Invalid: disabled.
IPv4
The status of IPv6.
Valid: enabled, Invalid: disabled.
IPv6
Master SVP details are provided in the format described below.
IPv4 (IPAddress: IP address, Subnet Mask: Subnet mask)
IPv6 (IPAddress: IP address, Subnet Prefix length: The value of subnet prefix)
M-SVP
IPv4(IPAddress,Subnet Mask)
IPv6(IPAddress,Subnet Prefix
length)
Standby SVP details are provided in the format described below.
IPv4 (IPAddress: IP address, Subnet Mask: Subnet mask)
IPv6 (IPAddress: IP address, Subnet Prefix length: The value of subnet prefix)
S-SVP
IPv4(IPAddress,Subnet Mask)
IPv6(IPAddress,Subnet Prefix
length)
[Install] Set Security Switch
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set Security Switch,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,Switch}=[{XX,Disable},{XX,Enable}],Num. of Ports=2
Detailed Information
DescriptionItem
The name of the port where the LUN security setting is changed.Port
Indicates whether the LUN security setting is enabled or disabled.
Disable or Enable will appear.
Switch
The number of ports where the LUN security setting is changed.Num. of Ports
80 Audit log examples
To Next Page
Loading...
Need help?
General