HP StorageWorks P9000 - Disk Arrays Reference Guide

+{LDKC:CU:LDEV,CommandDevSec}=[{0x00:0xXX:0xXX,Disable},
{0x00:0xXX:0xXX,Enable}],Num. of LDEVs=2
Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the command device is set.LDKC:CU:LDEV
Indicates whether the command device security setting is enabled or disabled.
Disable or Enable will appear.
CommandDevSec
The number of logical volumes where the command device is set.Num. of LDEVs
[Install] Set DevGrpDef
Example
07xx, YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set DevGrpDef,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,DevGrpDef}=[{0xXX:0xXX:0xXX,Enable}],
Num. of LDEVs=1
Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume where the device group definition is specified.LDKC:CU:LDEV
Indicates whether the device group definition is enabled or disabled.
Disable or Enable will appear.
UserAuth
The number of logical volumes where the device group definition is set.Num. of LDEVs
[Install] Set Fibre Address
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set Fibre Address,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,Fibre Addr.}=[{XX,0xXX(xx)},{XX,0xXX(xx)}],Num. of Ports=2
Detailed Information
DescriptionItem
The name of the port that the fibre address has been set.Port
The address of Fibre Channel port after the setting.
The outside of parenthesis indicates AL-PA (arbitrated-loop physical address) and the inside of
parenthesis indicates the loop ID.
Fibre Addr.
The number of ports where address has been set.Num. of Ports
[Install] Set Fibre Topology
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set Fibre Topology,,Normal end,
78 Audit log examples

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English