HP StorageWorks P9000 - Disk Arrays - [PROV] Set FCSP Target; [PROV] Set Fibre Address

{3E,Disable,0,unidirectional,2222222222222222}],
Num. of Ports=2
Detailed Information
DescriptionItem
The name of the port where authentication parameter has been set.Port
The setting status whether to execute authentication by port.
Disable: Do not authenticate, Enable: Authenticate
Switch
Not used. (fixed to 0)DH Group
The setting status of authentication method.
bi-directional: bi-directional authentication, unidirectional: unidirectional authentication
Auth
The user name of the port.UserName
The number of ports where authentication parameter has been set.Num. of Ports
[PROV] Set FCSP Target
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[PROV],Set FCSP Target,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,HostGrpID,Switch,DH Group,UserName}
=[{1E,0xXXX,Enable,0,1111111111111111},
{3E,0xXXX,Disable,0,2222222222222222}],
Num. of Grps=2
Detailed Information
DescriptionItem
The name of the port that includes the host group where authentication parameter has been
set.
Port
The number of the host group where authentication has been set.HostGrpID
The setting status whether to execute authentication by host group.
Disable: Do not authenticate, Enable: Authenticate
Switch
Not used. (fixed to 0)DH Group
The user name of the host group.UserName
The number of host groups where authentication parameter has been set.Num. of Grps
[PROV] Set Fibre Address
This log is output when LUN Manager operation is performed using Configuration File Loader.
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[PROV],Set Fibre Address,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,Fibre Addr.}=[{XX,0xXX(xx)},{XX,0xXX(xx)}],Num. of Ports=2
128 Audit log examples