HP StorageWorks P9000 - Disk Arrays Reference Guide

Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume where the user authentication is specified.LDKC:CU:LDEV
Indicates whether the user authentication is enabled or disabled.
Disable or Enable will appear.
UserAuth
The number of logical volumes where the user authentication is set.Num. of LDEVs
[Install] System Option
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],System Option,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+Spare Disk Recover=Full Speed
+Disk Copy Pace=Slower
+Copy Operation(Correction Copy)=OFF
+Copy Operation(Dynamic Sparing)=OFF
+Read Configuration Data Mode=OFF
+Link Failure Threshold=10
+{LDKC:CU:LDEV,Destage}=[{0x00:0x00:0x00,OFF}],
Num. of LDEVs=1
+{LPR,Cache Tuning}=[{System,Level5}],Num. of LPRs=1
+{LPR,Command Control}=[{System,10}],Num. of LPRs=1
+{LPR,Mode,Set}=[{System,0,ON}],Num. of Modes=1
+Debug Mode=Set
Detailed Information
DescriptionItem
Indicates the setting status of Spare Disk Recover.
Interleave: Give priority to the access from the host while executing copy process, Full speed:
Give priority to the copy process.
Spare Disk Recover
Indicates the setting status of Disk Copy Pace.
Slower: Low speed, Medium: Medium speed, Faster: High speed
Disk Copy Pace
Indicates the setting status of Copy Operation (Correction Copy).
ON: Execute Correction Copy, OFF: Do not execute Correction Copy
Copy Operation
(Correction Copy)
Indicates the setting status of Copy Operation (Dynamic Sparing).
ON: Execute Dynamic Sparing, OFF: Do not execute Dynamic Sparing
Copy Operation
(Dynamic Sparing)
The method to allocate the serial number reported by Read Configuration Data command.
ON: Method supporting 4096, OFF: Traditional compatible method
Read Configuration
Data Mode
The threshold to report link failure.Link Failure Threshold
The LDKC number, the CU number, and the LDEV number.LDKC:CU: LDEV
Indicates the setting status of Destage.
ON: Execute write through operation (report the completion of the writing to the host after the
writing to the disk drive has completed).
OFF: Do not execute write through operation (report the completion of the writing to the host
when the data is written in the cache memory).
Destage
82 Audit log examples

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English