HP StorageWorks P9000 - Disk Arrays - [Cnt Ac-S] Pairsplit-S; Continuous Access Synchronous Z Descriptions; [Cnt Ac-S Z] Add Pair

DescriptionItem
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of split pairs.Num. of Pairs
[Cnt Ac-S] Pairsplit-S
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[Cnt Ac-S],Pairsplit-S,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{P-VOL(Port-G-ID-LUN),S-VOL(Port-G-ID-LUN),Type,Force,Result}
=[{1A-0x00-0x000,1B-0x00-0x000,P-VOL,No,Normal end},
{1A-0x00-0x001,1B-0x00-0x001,P-VOL,No,Normal end},
+{1A-0x00-0x002,1B-0x00-0x002,P-VOL,No,Normal end},(snip)
-(snip)],Num. of Pairs=xx
Detailed Information
DescriptionItem
The port number, host group number, and LUN of the primary volume in the deleted pair
sequentially.
P-VOL(Port-G-ID-LUN)
The port number, host group number, and LUN of the secondary volume in the deleted
pair sequentially.
S-VOL(Port-G-ID-LUN)
The volume type of the volume on the primary site.
P-VOL: Primary volume, S-VOL: Secondary volume
Type
The setting for forced pair deletion.
Yes: Pair is deleted even when MCU cannot communicate with RCUNo: Pair is deleted
when MCU can change the pair status to SMPL only
Force
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of deleted pairs.Num. of Pairs
Continuous Access Synchronous Z Descriptions
[Cnt Ac-S Z] Add Pair
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx,, 00:00,RMI AP,uid=user-name,1,,
[Cnt Ac-S Z],Add Pair,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{M-VOL(LDKC:CU:LDEV),R-VOL(LDEV),S/N,LDKC,SSID,
Controller ID,Type,Initial Copy,Fence Level,
Copy Pace,Priority,Diff,CFW,DFW,TS,Result}
=[{0x00:0x00:0x00,0xFF,99999,0x00,0x0004,4,Sync,Entire,Never,15,
032,Auto,Only M-VOL,Required,Enable,Normal end},(snip)
-(snip)],Num. of Pairs=xx
152 Audit log examples