Table 32 Remote Copy > Continuous Access Journal Z
Audit Log OutputGUI operation
Operation NameFunction NameDescriptionSubmenu
Journal-Vol (Note 1)Cnt Ac-J ZEdit JNL VolumesJournal Operation
Change-JNL-Option (Note 1)Cnt Ac-J ZChange JNL Option
Journal-Vol (Note 1)Cnt Ac-J ZDelete JNL Groups
Change-Mirror-Option (Note 1)Cnt Ac-J ZChange Mirror Option
Suspend-Pair (Note 1)Cnt Ac-J ZSuspend Pair
Resume-Pair (Note 1)Cnt Ac-J ZResume Pair
Delete-Pair (Note 1)Cnt Ac-J ZDelete Pair
Journal-Vol (Note1)Cnt Ac-J ZRemove JNL from EXCTG
(Force)
R-Cmd.Dev. (Note 1)Cnt Ac-J ZAssign Remote Command
Device
R-Cmd.Dev. (Note 1)Cnt Ac-J ZRelease Remote
Command Device
Add-Pair (Note 1)Cnt Ac-J ZAdd PairPair Operation
Suspend-Pair (Note 1)Cnt Ac-J ZSuspend Pair
Resume-Pair (Note 1)Cnt Ac-J ZResume Pair
Delete-Pair (Note 1)Cnt Ac-J ZDelete Pair
Pair-Option (Note1)Cnt Ac-J ZChange Pair Option
Add RCURCUAdd Disk Controller (DKC)DKC Operation
Change RCU OptionChange Disk Controller
(DKC) Option
Delete RCUDelete Disk Controller
(DKC)
Add Path (Note 1) (Note 2)Add Path
Delete Path (Note 1) (Note 2)Delete Path
Edit Ports(Attr)PROVChanging port attribute
(Target, Initiator, RCU
Target)
System-Option (Note 1)Cnt Ac-J ZChange System OptionOptional Operation
System-Option (Note 1)Cnt Ac-J ZChange SIM Report
Clear-SIM (Note 1)Cnt Ac-J ZClear SIM
Edit-EXCTG (Note1)Cnt Ac-J ZAdd JNL to EXCTG
Remove JNL from EXCTG
EXCTG Operation
Note 1: When you apply two or more settings of the same type to the storage system at the same
time, the log information is output as one entry.
Note 2: If one or more settings end abnormally when you have applied at one time, the output
log information is Error, not Warning.
206 Audit log user operations
To Next Page
Loading...
Need help?
General