HP StorageWorks P9000 - Disk Arrays Reference Guide

Table 49 Syslog Window
DescriptionItem
Specify whether to transfer the audit log to the primary syslog server.
• Enable: Transfers the audit log.
• Disable: Does not transfer the audit log.
Output to Primary
Server
Set an IP address and a port number for the primary syslog server. Once you set Output to
Primary Server to Enable, IP and Port become available. For both IP and Port, the defaults have
been entered, so change them as needed.
You can set either IPv4 address or IPv6 address for IP address. However, only IPv4 address is
available when the operating system of your SVP is Windows XP.
• To set an IPv4 address, select IPv4. For IP, enter four integers in the range of 0 to 255 (for
example, nnn.nnn.nnn.nnn, where n is a number). Only enter numbers. Do not enter the
intervening periods.
• To set an IPv6 address, select IPv6. For IP, enter eight hexadecimal numbers in the range of
0 to FFFF (for example, hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hhhh, where h is
a hexadecimal digit). Only enter hexadecimal numbers. Do not enter the intervening colons.
• For Port, enter one integer in the range of 1 to 65,535.
Primary Server
Setting
Specify whether to transfer the audit log to the secondary syslog server.
• Enable: Transfer the audit log.
• Disable: Does not transfer the audit log.
Output to Secondary
Server
Set an IP address and a port number for the secondary syslog server. Once you set Output to
Secondary Server to Enable, IP and Port become available. For both IP and Port, the defaults
have been entered, so change them as needed. The restriction for the available values is the
same as that of Primary Server Setting.
Secondary Server
Setting
Name, as you like, the storage system that transfers the audit log to syslog servers, so that you
can identify the storage system. Enter 32 one-byte characters at the maximum. Available
characters are alphabets (A-Z and a-z), numeric (0-9), and symbols ( ! " # $ % & ' ( ) = - ~ ^
| \ { } [ ] @ ` : ; * + _ ? / < > .). However, a comma (,) and a space cannot be used.
Location
Identification Name
Set whether to transfer the detailed information of the audit log file to the syslog server. If you
want to transfer the detailed information to the syslog server, select Enable. If you do not, select
Disable. In the syslog file that is stored in the SVP, the detailed information is always stored
regardless of this setting.
Output Detailed
Information
Downloads the syslog file to the Remote Web Console computer.Download Syslog
Implements all the settings. This button is available only in Modify mode.Apply
Cancels all the settings. This button is available only in Modify mode.Cancel
216 Audit log GUI reference

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English