Networking 540
20. You should see a message welcoming you to the Domain!
21. If joining a Workgroup FROM a Domain you will be prompted for a username and password for
someone that can remove the control from a pre-existing Domain ( ie. HTA.com ). In this case you
should use User name: cnc\administrator
Password: 1396
22. You will see a message welcoming you to the Workgroup!
23. Power down the controller and restart. When you power up the control it will be connected to the
network, and you will be logged onto the “LOCAL MACHINE” as the Administrator. THIS IS NOT
THE SAME AS BEING AN ADMINISTRATOR ON THE NETWORK. At this point the control is
To Next Page
Loading...
