9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-26
■ Entering information into Repeater List
D New repeater entry (Continued)
3. Entering the repeater name
!0 Push D-pad(
) to select “NAME,” and then push D-
pad(Ent) to enter the repeater name edit mode.
!1 Rotate [DIAL] to select a desired character.
• Selectable characters are upper case letters, lower case
letters, numbers or symbols.
• The selected character blinks.
• Push D-pad() to move the cursor forward or backward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode.
• Rotate [DIAL] counterclockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-8 for entry details.
!2 Push D-pad() to move the cursor to the second
digit.
!3 Repeat steps !1 and !2 to enter a name of up to 16
characters, including spaces.
!4 After entering the name, push D-pad(Ent).
Character type
selection screen
Example:
“East Tokyo” is
entered.
☞ Continued on the next page.
Shows the currently se-
lected character type
To Next Page
Loading...
Need help?
General
