Icom ID-51A

9
D-STAR OPERATION <ADVANCED>
9-27
■ Entering information into Repeater List
D New repeater entry (Continued)
4. Entering the repeater sub name
!5 Push D-pad(
) to select “SUB NAME,” and then
push D-pad(Ent) to enter the repeater sub name edit
mode.
D-pad
()
(Ent)
!6 Rotate [DIAL] to select a desired character.
• Selectable characters are upper case letters, lower case
letters, numbers or symbols.
• The selected character blinks.
• Push D-pad() to move the cursor forward or backward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode.
• Rotate [DIAL] counterclockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-8 for entry details.
!7 Push D-pad() to move the cursor to the second
digit.
!8 Repeat steps !6 and !7 to enter a sub name of up to
8 characters, including spaces.
!9 After entering the name, push D-pad(Ent).
Character type
selection screen
Example:
“Japan” is en-
tered.
☞ Continued on the next page.
Shows the currently se-
lected character type
Previous view