9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-28
■ Entering information into Repeater List
D New repeater entry (Continued)
5. Entering the repeater call sign
When used for simplex communication, go to
[8. Setting the access repeater].
@0 Push D-pad(
) to select “CALL SIGN,” and then
push D-pad(Ent) to enter the repeater call sign edit
mode.
@1 Rotate [DIAL] to select the first character.
• A to Z, 0 to 9, / and a space can be selected.
• A space can be entered in any input mode.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
@2 Push D-pad() to move the cursor to the second
digit.
@3 Repeat steps @1 and @2 to enter a name of up to 8
characters, including spaces.
@4 After entering the call sign, push D-pad(Ent).
Example:
“JP1YYY A” is
entered.
☞ Continued on the next page.
TIP: Be sure to add a repeater node (port) letter as
the 8th digit in the call sign field after a repeater call
sign, according to the repeater frequency band, as
shown below.
Note that Japanese repeater node letters are differ-
ent.
1200 MHz : A (B in Japan)
430 MHz : B (A in Japan)
144 MHz : C (no D-STAR repeaters in Japan)
Cross band operation between different nodes at the
same repeater site can be made.
To Next Page
Loading...
Need help?
General
