9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-29
■ Entering information into Repeater List
D New repeater entry (Continued)
6. Entering the gateway repeater call sign
The 8th digit in the call sign, entered in [5. Entering
the repeater call sign] is automatically set to “G” as
the gateway port. You can skip this setting and go to
the next item. If you need to change it, follow the steps
described below.
@5 Push D-pad(
) to select “GW CALL SIGN,” and then
push D-pad(Ent) to enter the gateway repeater call
sign edit mode.
@6 Rotate [DIAL] to select the first character.
• A to Z, 0 to 9, / and a space can be selected.
• A space can be entered in any input mode.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
@7 Push D-pad() to move the cursor to the second
digit.
@8 Repeat steps @6 and @7 to enter a name of up to 8
characters, including spaces.
• The 8th digit in the gateway repeater call sign is set to
only “G” or a space.
@9 After entering the gateway repeater call sign, push
D-pad(Ent).
7. Viewing the repeater group
In this item, you can view the repeater group that is
selected in [1. Selecting the repeater group]. You can
skip this setting and go to the next item.
If necessary, you can change the repeater group.
#0 Push D-pad(
) to select “GROUP,” and then push D-
pad(Ent) to enter the repeater group selection mode.
#1 Push D-pad() to select the desired repeater group
(01 to 30), and then push D-pad(Ent).
• The selected repeater group is displayed on the RE-
PEATER LIST EDIT screen.
☞ Continued on the next page.
Example:
“JP1YYY G” is
entered.
To Next Page
Loading...
Need help?
General
