9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-30
■ Entering information into Repeater List
D New repeater entry (Continued)
8. Setting the access repeater
You can use the entered repeaters as access repeat-
ers when using the DR function.
For simplex operation, or when the entered repeater
is not used as an access repeater, select “NO.” In this
case, the entered repeater does not appear in the
“FROM” selection.
#2 Push D-pad(
) to select “USE(FROM),” and then
push D-pad(Ent).
#3 Push D-pad() to select “YES,” and then push D-
pad(Ent).
• You can select the entered repeater as an access re-
peater (FROM).
9. Entering the access repeater frequency
#4 Push D-pad(
) to select “FREQUENCY,” and then
push D-pad(Ent) to enter the frequency edit mode.
• A cursor appears and blinks.
#5 Rotate [DIAL] to enter the 100 MHz digit of the fre-
quency.
#6 Push to move the cursor backward, or push to
move the cursor forward.
#7 Repeat steps #5 and #6 to enter the frequency.
#8 After entering, push D-pad(Ent).
Example:
“439.340.00” is
entered.
☞ Continued on the next page.
To Next Page
Loading...
Need help?
General
