6
BC RADIO OPERATION
6-11
3. Entering a frequency
!2 Push D-pad() to select “FREQUENCY,” and then
push D-pad(Ent).
• A cursor appears and blinks.
!3 Rotate [DIAL] to enter the frequency.
• AM: 520 to 1710 kHz
• FM: 76.0 to 108.0 MHz*
* Frequency range differs, depending on the transceiver’s
version.
!4 Push D-pad() to move the cursor forward or back-
ward to edit the frequency.
!5 Repeat steps !3 and !4 to enter the frequency.
!6 After entering, push D-pad(Ent).
4. Selecting the skip setting
!7 Push D-pad() to select “SKIP,” and then push D-
pad(Ent).
!8 Push D-pad() to select whether or not to use the
channel in the BC Radio memory.
• OFF: You can select the channel in the BC Radio
memory.
• Skip: The channel does not appear in the BC Radio
memory.
!9 After selecting, push D-pad(Ent).
5. Writing BC Radio Memory
@0 Push D-pad() to select “<<Add Write>>,” and then
push D-pad(Ent).
• If a previously added BC Radio memory is edited, select
“<<Overwrite>>.”
@1 Push D-pad() to select “YES,” and then push D-
pad(Ent).
To cancel the entered data:
q To cancel the entered
data, push [CLR]
to
display “Cancel edit?.”
w Push D-pad(
) to select
“YES,” and then push D-
pad(Ent) to cancel enter-
ing and return to the BC
Radio Memory’s channel
list screen.
(Example)
When entering
“88.9”
(Example)
When “FM-K Station” is
assigned to Bank K.
Select
■ Adding or editing BC Radio memory (Continued)
The list of BC Radio Bank K
is displayed.
To Next Page
Loading...
Need help?
General
