15 Secure the rear part of the 550‑sheet tray to the printer.
16 Connect one end of the power cord to the printer, and then the other end to the electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord
to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.
17 Turn on the printer.
Add the tray in the print driver to make it available for print jobs. For more information, see
“Adding available
options in the print driver” on page 96.
Installing the 2000-sheet tandem tray
Installing the 2000-sheet tandem tray
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
Notes:
• This option must be installed together with an optional 550‑sheet tray. Placed this option at the bottom
of the configuration.
• If a 550‑sheet tray is already installed, uninstall the tray, remove the tray side cover, remove the lower
tray cover, and then place the tray on top of this option.
Set up, install, and configure 110
To Next Page
Loading...
