Lexmark CX833 - Connecting the printer to a wireless network using Wi-Fi Protected Setup (WPS); Configuring Wi-Fi Direct

Connecting the printer to a wireless network using Wi‑Fi Protected Setup
(WPS)
Before you begin, make sure that:
• The access point (wireless router) is WPS‑
certified
or WPS‑compatible. For more information, see the
documentation that came with your access point.
• A wireless network adapter is installed in your printer. For more information, see the instructions that came
with the adapter.
• Active Adapter is set to Auto. From the control panel, navigate to Settings > Network/Ports > Network
Overview > Active Adapter.
Using the Push Button method
1
From the control panel, navigate to Settings > Network/Ports > Wireless > Wi‑Fi Protected Setup > Start
Push Button Method.
2 Follow the instructions on the display.
Using the personal identification number (PIN) method
1
From the control panel, navigate to Settings > Network/Ports > Wireless > Wi‑Fi Protected Setup > Start
PIN Method.
2 Copy the eight‑digit WPS PIN.
3 Open a web browser, and then type the IP address of your access point in the address
field.
Notes:
• To know the IP address, see the documentation that came with your access point.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
4 Access the WPS settings. For more information, see the documentation that came with your access point.
5 Enter the eight‑digit PIN, and then save the changes.
Configuring
Wi‑Fi Direct
Wi-Fi Direct
®
enables Wi‑Fi devices to connect directly to each other without using an access point (wireless
router).
1 From the control panel, navigate to Settings > Network/Ports > Wi-Fi Direct.
2 Configure the settings.
• Enable Wi‑Fi Direct—Enables the printer to broadcast its own Wi‑Fi Direct network.
• Wi‑Fi Direct Name—Assigns a name for the Wi‑Fi Direct network.
• Wi‑Fi Direct Password—Assigns the password for negotiating the wireless security when using the
peer‑to-peer connection.
• Show Password on Setup Page—Shows the password on the Network Setup Page.
• Preferred Channel Number—Assigns the preferred channel of the Wi‑Fi Direct network.
Set up, install, and configure 252