Installing the staple, hole punch finisher and paper transport with folding
option
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
Note: This task requires a flat‑head screwdriver.
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet, and then from the printer.
3 Unpack the paper transport with folding option, and then remove all the packing material.
4 Remove the standard bin.
Note: Do not throw away the bin.
Set up, install, and configure 176
To Next Page
Loading...
