Lexmark CX833 - Sending an email

Setting Value
Device Password App password
Note: To create an app password, go to the
Yahoo Account Security page,
log in to your account, and then from the App password section, click
Generate app password.
Zoho Mail
Setting Value
Primary SMTP Gateway smtp.zoho.com
Primary SMTP Gateway Port 587
Use SSL/TLS Required
Require Trusted Certificate Disabled
Reply Address Your email address
SMTP Server Authentication Login / Plain
Device‑Initiated E‑mail Use Device SMTP Credentials
Device UserID Your email address
Device Password Account password or app password
Notes:
• For accounts with two‑step verification disabled, use your account
password.
• For accounts with two‑step verification enabled, use an app password. To
create an app password, go to the
Zoho Mail Account Security page, log
in to your account, and then from the Application‑Specific Passwords
section, click Generate New Password.
Sending an email
Before you begin, make sure that the SMTP settings are configured. For more information, see “Configuring
the SMTP settings” on page 266.
1 Load an original document into the ADF tray or on the scanner glass.
2 From the control panel, navigate to Scan > E-mail.
3 Enter the needed information, and then select Next.
If necessary, configure the settings.
4 Select Scan, and then send the email.
E-mail 273