Lexmark CX833 - Installing the offset stacker

23 Connect one end of the printer power cord to the printer, and then the other end to the electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of
fire
or electrical shock, connect the power cord
to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.
24 Turn on the printer.
Add the finisher in the print driver to make it available for print jobs. For more information, see
“Adding available
options in the print driver” on page 96.
Installing the oset stacker
Installing the oset stacker
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
1 Turn o the printer.
Set up, install, and configure 140