Lexmark CX833 - Using the on-screen keyboard; Enabling Magnification mode; Adjusting the Voice Guidance speech rate; Adjusting the default headphone volume

Using the on‑screen keyboard
When the on‑screen keyboard appears, do one or more of the following:
• Touch a key to announce and type the character in the field.
• Drag a finger across dierent characters to announce and type the character in the field.
• Touch a text box using two fingers to announce the characters in the field.
• Tou ch Backspace to delete characters.
Enabling
Magnification
mode
1 In one motion and using one finger, slowly swipe left then up on the display until you hear a voice message.
Note: For printer models without built-in speakers, use headphones to hear the message.
2 Using two fingers, do the following:
a To uc h
Magnification
mode.
b Touc h OK.
Note: If the gesture does not work, then apply more pressure.
For more information on navigating a magnified screen, see
“Navigating the screen using gestures” on page
68.
Adjusting the Voice Guidance speech rate
1 From the control panel, navigate to Settings > Device > Accessibility > Speech Rate.
2 Select the speech rate.
Adjusting the default headphone volume
1 From the control panel, navigate to Settings > Device > Accessibility.
2 Adjust the headphone volume.
Note: The volume resets to the default value after the user exits Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
Adjusting the default internal speaker volume
1 From the control panel, swipe right to the control center.
2 Adjust the volume.
Notes:
• If Quiet Mode is enabled, then the audible alerts are turned o. This setting also slows the printer
performance.
• The volume resets to the default value after the user exits the Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
Set up, install, and configure 72