Lexmark CX833 - Setting up fax using a standard telephone line

Notes:
• View the printer IP address on the control panel. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax.
3 From the Fax Mode menu, select Fax Server, and then click Save.
4 Click Fax Server Setup.
5 In the To Format
field,
type [#]@myfax.com, where [#] is the fax number and myfax.com is the fax provider
domain.
Notes:
• If necessary, configure the Reply Address, Subject, or Message fields.
• To let the printer receive fax messages, enable the device‑based fax receive setting. Make sure that
you have a device‑based fax configured.
6 Click Save.
7 Click Fax Server Email Settings, and then enable Use Email SMTP Server.
Note: If the settings are not
configured,
then see
“Configuring
the SMTP settings” on page 266.
8 Apply the changes.
Setting up fax using a standard telephone line
Setting up fax using a standard telephone line
Note: These instructions apply only to printers that have a fax card installed.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, do not set up this product or make
any electrical or cabling connections, such as the power cord, fax feature, or telephone, during a
lightning storm.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, do not use the fax feature during a
lightning storm.
CAUTION—POTENTIAL INJURY: To reduce the risk of fire, use only a 26 AWG or larger
telecommunications (RJ-11) cord when connecting this product to the public switched telephone
network. For users in Australia, the cord must be approved by the Australian Communications and Media
Authority.
Set up, install, and configure 75