Lexmark CX833 - SNMP

Menu item Settings Description
Raw Print Port 1–65535 (9100*) Specify a raw port number for printers
connected on a network.
Outbound Trac
Maximum Speed
O*
On
Set the maximum transfer rate of the printer.
Note: When enabled, the option for this
setting is 100–1000000 Kilobits/second.
TLS Support Enable TLSv1.0 (O*)
Enable TLSv1.1 (O*)
Enable TLSv1.2 (On*)
Enable the Transport Layer Security protocol.
SSL Cipher List The setting is user-defined. Specify the cipher algorithms to use for the SSL
or the TLS connections.
TLSv1.3 SSL
Cipher List
Note: An asterisk (*) next to a value indicates the factory default setting.
SNMP
Note: This menu appears only in network printers or printers that are attached to print servers.
Menu item Submenu Item Settings Description
SNMP Versions 1
and 2c
Enabled O
On*
Configure Simple Network
Management Protocol (SNMP)
versions 1 and 2c to install
print drivers and applications.
Allow SNMP Set O
On*
Enable PPM MIB O
On*
SNMP Community The setting is user-defined.
Note: An asterisk (*) next to a value indicates the factory default setting.
Printer menus 357