Scanning to a network folder
Before you begin, make sure that the network folder that you wan to scan the document to is already
configured.
1 Load an original document into the ADF tray or on the scanner glass.
2 From the control panel, navigate to Scan Center > Network Folder.
3 Select the applicable network folder.
Note: To add a network folder, see “Configuring a network folder destination” on page 280.
4 Scan the document.
Configuring
a network folder destination
Configuring a network folder destination
1 From the control panel, navigate to Scan Center > Network Folder > Create Network Folder.
2 Configure the necessary settings.
3 Log in to the network, and then select Next.
4 Configure the network folder settings, and then select Done.
Note: To scan a document to a network folder, see
“Scanning to a network folder” on page 280.
Creating a network folder shortcut
1 Open a web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Shortcuts > Add Shortcut.
3 From the Shortcut Type menu, select Network Folder, and then configure the settings.
4 Apply the changes.
Scanning to a flash drive
Scan 280
To Next Page
Loading...
