Sensor (ADF media exit) late leaving or not cleared jam service check
Action Yes No
Step 1
Check the media path for contaminates.
Is the media path free of excess media dust and foreign objects such as
paper clips and staples?
Go to step 2. Remove all
contaminates from the
media path.
Step 2
Check the ADF output bin for obstructions.
Is the ADF output bin free from obstructions?
Go to step 3. Remove all
obstructions.
Step 3
Check the ADF bottom door for proper closing.
Is the ADF bottom door properly closed?
Go to step 4. properly close the ADF
bottom door.
Step 4
Check the sensor (ADF media exit) for proper operation.
a Enter the Diagnostics Menu.
b Touch SCANNER TESTS.
c Touch Sensor Tests.
d Observe the line "sensor (ADF media exit)."
Does the display on the operator panel change every time the sensing
area of the sensor is interrupted or blocked?
Go to step 6. Go to step 5.
Step 5
Check the sensor (ADF media exit) for proper connection.
Is the component properly connected?
Replace the sensor
(ADF media exit). Go to
“Interrupt with flag
sensor (ADF media
exit) removal” on
page 615.
Replace the
connection.
Step 6
Check the ADF transport motor for proper operation.
a Enter the Diagnostics Menu.
b Touch TESTS.
c Touch Transport Motor/Deskew Clutch.
d Touch either Motor Forward or Motor backward
e Perform the test.
Does the ADF pick motor operate properly?
Go to step 8. Go to step 7.
Step 7
Check the ADF transport motor for proper connection.
Is the above component properly connected?
Replace the ADF rear
side drive parts pack.
Go to
“ADF rear side
drive parts pack
removal” on page
600.
Replace the
connection.
7463
Diagnostic information
155
To Next Page
Loading...
