Min copy memory
Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at least
200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1 Select Min Copy Memory from the Configuration Menu. [setting's current value] displays.
2 Select one of the three settings: disable, sleep permit or sleep auto
3 Select the minus to decrease the setting's value or the plus to increase the setting’s value.
4 Select Submit to save the change.
Fax low power support
Fax Low Power support allows you to select one of three power settings for the fax. The Auto value relies on the
firmware’s logic to determine if the device supports the fax portion of the low power architecture. Permit Sleep allows
the fax chip to enter low power mode whenever the device determines that it should. Disable Sleep prohibits the fax
chip from ever entering low power mode.
To change the fax low power support setting:
1 Select Fax low-power support in the configuration menu to open the item
2 Select one of the three settings: disable, sleep permit or sleep auto
3 Select the check sign to accept the setting or press the X on the screen to exit the item.
Num pad job assist
This setting determines if a user can configure and initiate a job using the control panel’s hard buttons.
To change this setting:
1 Select Num Pad Job Assist from the Configuration Menu. [setting's current value] displays.
2 Select the minus to decrease the setting's value or the plus to increase the setting’s value.
3 Select Submit to save the change.
Format fax storage
This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1 Select Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, then you must enter this password to change the setting.
If no advanced password exists, then you can establish one by using the keyboard that appears on the LCD.
2 Select Submit to save the change.
3 Select Back to cancel and return to the Configuration Menu. Formatting Fax Flash DO NOT POWER OFF
appears on the display while the format operation is active.
7463
Service menus
361
To Next Page
Loading...
